Short answer
Drywall that is soft, swollen or crumbling has taken on water and comes out, along with the baseboard in front of it. Drywall that is only stained and still hard under your thumb gets sealed with a stain-blocking primer and painted. Fix the leak and let the wall dry completely before either repair, because new drywall over a damp cavity fails.
Tell wet drywall from a dry stain in a minute
- Fix the leak first. A wall that keeps getting wet cannot be repaired, and new drywall fails within weeks.
- Let the cavity dry. Pull the baseboard or cut a small hole at the bottom, then run a fan on it for about a week.
- Press the worst spot with your thumb, then with the handle of a screwdriver. Note how far it sinks.
- Pick at the edge of the stain with a fingernail. Paper that lifts, crumbles or peels away is wet damage, not a mark.
- Look at the wood bottom plate through the opening and press it the same way. Soft wood there means the framing is wet, not just the board.
- Sniff the cavity and look at the back of the board for dark patches. A musty smell or black spots mean mold.
If the drywall stays hard and only the paint or paper is marked, clean it, seal it with a stain-blocking primer and paint it. If it sinks in, feels spongy or crumbles, cut that section of drywall out and replace it.
Repair or replace
| Situation | What to do |
|---|---|
| Stained, still hard to the touch | Clean, seal with a stain-blocking primer and repaint. No cutting. |
| Soft, swollen or crumbling at the bottom | Cut out the damaged section, replace the drywall and reinstall the baseboard. |
| Damage down behind a baseboard or into a corner | Replace the baseboard too. Water sits in the joint and rots the trim before the board. |
| Damage wider than one sheet or higher than the bottom 12 inches | Replace the full sheet so the taped seam lands on a stud, not in open wall. |
| Bottom plate or studs soft when you press them | Hire a carpenter. The framing gets repaired before any new drywall goes on. |
| Mold on the back of the board or a musty smell | Hire for this. Cut out and treat the area. Painting over mold traps it. |
What it costs
Runhome contractor estimates for cutting out and replacing water-damaged drywall and blending the paint ran from $333 to $690 as of November 2026, including the trip and assessment.
| Option | Range |
|---|---|
| Cut out the damaged section, replace the drywall, reuse the baseboard and blend the paint | $333 to $690 |
Can I do it myself?
You can patch and repaint stained but firm drywall yourself. You can also cut out and replace a small section if you are comfortable taping and blending texture, though matching an existing wall texture is the part most homeowners cannot do well. Hire for anything involving a wet cavity, soft framing, mold, or a repair wider than one sheet, and hire for a moisture check before new drywall goes on, because a patch over a damp wall fails and grows mold behind it.
What a contractor will ask you
Have these ready and you skip the back-and-forth.
- How wide the damaged section is across the wall.
- Whether the wall is interior or exterior.
- How high up from the floor the damage goes.
- Whether the drywall is only stained or soft and crumbling.
- When the leak or flood stopped and how long the area has been dry.
- Which room the wall is in.
- The wall finish, whether there is baseboard, trim or wallpaper to reinstall.
- Whether furniture or fixtures block access to the wall.
- Whether you want the whole wall repainted or just the repair blended.
- What is inside the wall cavity, and whether the insulation got wet.
Common questions
- Do I have to replace drywall that got wet?
Only if it is soft, swollen or crumbling. Drywall that got wet but dried out and stayed hard gets sealed and painted.
- The leak is fixed and the wall feels dry. Can I just paint over the stain?
Yes, if the board is still hard. Coat the stain with a stain-blocking primer first, or the brown mark bleeds back through the paint.
- Can I replace just the bottom of the wall or do I need a full sheet?
Replace the bottom section up to the nearest stud if the damage stays in the bottom foot or so. Wider damage gets a full sheet so the new seam lands on a stud.
- How long does the wall have to dry before it is repaired?
Give it about a week with air moving across the opening. A cavity that is still damp when the new drywall goes on grows mold behind the wall.
- Does the baseboard have to come off?
Yes, if the drywall behind it is damaged. The baseboard traps water against the bottom plate, so it comes off and gets reused only after the wall is dry.
