Skip to content

Other home repairs

Kitchen cabinet bottom is moldy after a leak

A cabinet bottom that is dry and hard gets replaced without touching the cabinet box. Here is how to tell dried-out staining from active moisture and what the repair costs.

3D illustration of an open toolbox holding a hammer, screwdriver, tape measure and putty knife, with a door hinge, loose screws and a roll of tape beside it

Reviewed by Josh Arneson, Handyman and Property ManagerPublished

Short answer

A moldy cabinet bottom is a panel problem, not a whole-cabinet problem. Press the panel first. A bottom that feels hard under your thumb has dried out, so the damaged panel and the lower wall liners get cut out and replaced with moisture-resistant ones. A bottom that feels soft, or mold that keeps coming back, means water is still reaching the wood and that gets fixed before any new panel goes in. The cabinet box, the doors and the countertop stay.

Tell a dried cabinet bottom from active moisture

  1. Open both doors and look at the whole cabinet floor with a flashlight.
  2. Press the bottom panel with your thumb or the handle of a screwdriver. Hard means the wood has dried out.
  3. Wipe the dark area with a clean cloth and a little household cleaner. Stain wipes off, mold leaves a residue that comes back.
  4. Feel a few inches up the side and back walls. Water wicks upward, so the lower liner is often damaged with the bottom.
  5. Run the faucet and watch the drain and the supply fittings under the sink for a few minutes. Any drip means the leak is still live.
  6. Close the doors and smell inside the cabinet. A musty smell that stays after cleaning means damp wood is still there.

If the panel is hard, the stain wipes away and the fittings stay dry, clean and seal the inside and keep the cabinet. If the panel is soft, the mold returns or the smell stays, the bottom panel and the lower liners get cut out and rebuilt.

Repair or replace

SituationWhat to do
Bottom panel hard, only stainedClean, treat and seal it. Keep the cabinet.
Bottom panel soft or swollenCut out the bottom panel and fit a moisture-resistant one. Keep the box.
Mold on the bottom and up the side wallsReplace the bottom panel and the lower liners at the same time.
Bottom and side walls both crumblingRebuild the sink base cabinet. New edges have nothing sound to fasten to.
Water still reaching the cabinetFix the leak first. A new panel under a live drip rots again in months.

What it costs

Runhome contractor estimates for replacing a moldy cabinet bottom panel and the lower wall liners ran from $345 to $725 as of November 2026, including the trip, mold treatment and sealant.

OptionRange
Replace the bottom panel and the lower wall liners$345 to $725

Can I do it myself?

Yes for cleaning and sealing, and no for cutting the panel out. Scrubbing, treating and repainting the inside of a cabinet is a homeowner job. Fitting a new bottom panel is harder than it looks, because the panel sits behind the sink base and the box has to be squared and sealed again. Hire a carpenter when the panel is soft, when the side walls are wet too, or when the cabinet sits in the middle of a run with no access from behind. Work on plastic sheeting with the doors off, and wear a mask and gloves if you treat mold.

What a contractor will ask you

Have these ready and you skip the back-and-forth.

  • How long the staining has been there, and whether the leak above it is fixed.
  • Whether the bottom feels hard or soft when you press it.
  • Whether the damage is only the flat bottom or the side walls too.
  • Whether you want the whole cabinet replaced or just the bottom panel.
  • Whether there is any access to the cabinet from behind.
  • A wide photo of the open cabinet showing the bottom, the fittings and the surrounding wall.

Common questions

Can I replace just the bottom of the cabinet and keep the cabinet?

Yes. When the sides and the front frame are sound, a carpenter cuts the damaged bottom panel out and fits a new moisture-resistant one. The box, the doors and the countertop stay.

The cabinet bottom is moldy now that the leak is fixed, do I need a new cabinet?

No. Once the leak stops and the wood dries, the moldy panel comes out and a new panel goes in. A new cabinet is only needed when the side walls are crumbling too.

Will bleach kill the mold on the cabinet bottom?

Bleach lightens the stain but does not reach into wood or particleboard. If the panel is still soft, no cleaner makes it solid again. Plan on replacing the panel.

Is a moldy cabinet bottom dangerous?

Surface mold on a panel that has dried is a cleaning job. Mold that grows back because the material is still damp is the real problem. Take out the damp panel.

How much does it cost to replace a cabinet bottom panel?

Runhome contractor estimates run from $345 to $725 as of November 2026. That covers the trip, the labor, the new panel and liners, mold treatment and sealant.

Want this handled?

Hand it off and Runhome confirms the diagnosis, calls vetted contractors, and sends you one price to approve.